Tel: +86-13921366778


Home > Knowledge > Content
Some precautions during the use of the automatic slitting machine
- Feb 02, 2019 -

Automatic slitting machine is a kind of mechanical equipment for slitting wide-width paper or film into a plurality of narrow-width materials. It is commonly used in papermaking machinery and printing and packaging machinery. It has the advantages of stable operation, convenient operation, strong adaptability and high output.
Before the automatic slitting machine is put into operation, we must first check whether the working positions are properly adjusted. If lubrication is required, the grease should be added in advance to check whether the tool is sharp.
Before the automatic slitting machine is ready for operation, all personnel must notify the departure device to ensure personal safety before starting operation; avoid touching the running film roll or roll core with your hands to avoid personal injury caused by hand roll; avoid using knife or hard Scratches and cuts each roll core.
When using the automatic slitter, we must ensure that the voltage, current and hydraulic equivalents are correct and stable before starting. After all the normal, you can run the empty car first, check whether there is any abnormality, and input the processing order into the computer to check the order in advance; after the equipment is put into operation, adjust the optimal working condition of the equipment according to the production situation to ensure the cutting machine indentation. Moderate, cut without burrs, and the trimming position on both sides is appropriate. It is also necessary to monitor the operation of the machine at all times, and beware of paper jams and defective products.
After the work is completed, clean the dust and paper scraps on the automatic slitter in time, check the cutter and the sharpening wheel, drain the oil in the water purifier and the water in the gas storage tank, and check whether there is any abnormality in the running part. Then, according to the instructions, cut off the power supply and maintain the computer operating system.